Issues
- 0
Bed wont heat
#40 opened by destruct123 - 0
- 2
Bootloader missing
#20 opened by gabber130779 - 1
CM4 + BTT TFT35 SPI V2.1
#29 opened by djeZo888 - 0
How do I: Control a USB ported Fan for my enclosure?
#38 opened by Valiance - 19
Manta E3EZ with rp3 connection
#8 opened by bmorgan99 - 1
Manta E3EZ CB1 dual display BTT TFT35SPI and HDMI7 touch dont work at the same time
#26 opened by MetalWorks666 - 3
I upgraded to a Manta E3EZ and Melted the Y-axis Stepper Motor (housing) off my printer!
#34 opened by lugfug - 0
- 0
- 0
USB Not recognized at all
#35 opened by wil-sys - 10
Klipper Screen on 3.5 Inch TFT Screen
#18 opened by Doormat1 - 0
Z_Endstop is always open
#33 opened by sabergo1 - 0
USB connection in marlin
#32 opened by meysamsb - 10
- 17
Where is Marlin???
#15 opened by Tina-Builds - 0
STEP File doesn't load USB, ethernet or hdmi
#31 opened by elimisback - 6
the guide doesnt show all the pins!!
#10 opened by MasterSe7en777 - 1
Unable to see MCU
#30 opened by Deapper - 20
How To put board in DFU Mode
#2 opened by emersonsc - 13
How to setup the internal CAN interface?
#1 opened by rclarke250 - 2
Can't update MCU
#28 opened by Deapper - 1
- 1
Manta E3EZ+CB1+EBB36 v1.2
#9 opened by alexandrugai - 1
Uploading bootloader
#24 opened by killrmodz - 0
Stepper driver SPI bus
#25 opened by agentmcmillan - 8
Ender 3 v2 Enclosure Damages SD Card
#3 opened by cmcfalls2 - 2
Manta E3EZ Step and PDF files in 3D directory in this repository appear to be corrupt.
#23 opened by Cruzg74 - 0
"/serial/" directory restoration
#22 opened by BelowCelcius - 0
cant ssh into cb1
#21 opened by tristengrim - 1
Heating issues
#19 opened by Wmelonhead - 1
Poor canbus labelling
#13 opened by Tina-Builds - 1
How to boot in DFU mode
#16 opened by Tina-Builds - 1
- 5
Ender 3 Pro support
#4 opened by emersonsc - 1
- 1
Camera Not Working
#14 opened by Wmelonhead - 1
HDMI Port, what kind is it?
#11 opened by Valiance - 0
Manta E3 EZ with CB1 Klipper
#7 opened by Fieroman911 - 1
Manta EZ 3 and Sprite Extruder
#6 opened by jeremi2305