bobc/bobc_hardware

Issues

• Update... would it make sense?

  #34 opened 6 years ago by boelle
  121

• Thermistor readings incorrect

  #26 opened 11 years ago by bobc
  3

• 5V drivers logic

  #33 opened 7 years ago by rafaljot
  3

• Ramps-FD: I like buy empty pcb

  #29 opened 8 years ago by pityuka3d
  1

• GERBER, Schematic and BOM do not match

  #32 opened 7 years ago by Kondziol
  1

• RAMPS-FD: LM7812 gets very hot

  #30 opened 8 years ago by fullTalgoRythm
  1

• DXF file for RAMPS-FD board

  #28 opened 9 years ago by YasuoSuto
  3

• RAMPS-FD: Change to endstop pins

  #4 opened 11 years ago by cefiar
  1

• RAMPS-FD: Improve ground connections

  #23 opened 11 years ago by cefiar
  1

• RAMPS-FD: 5V rail needs more current

  #11 opened 11 years ago by bobc
  3

• RAMPS-FD: Outputs D2 and D12 are on when firmware downloaded

  #18 opened 11 years ago by bobc
  1

• RAMP-FD: heater outputs are on if power from Due not present

  #19 opened 11 years ago by bobc
  1

• RAMPS-FD: add I2C EEPROM

  #20 opened 11 years ago by bobc
  1

• RAMPS-FD: add SD connector?

  #21 opened 11 years ago by bobc
  0

• RAMPS-FD: Clean up tracks around Arduino Due mounting hole (near Pin 21).

  #16 opened 11 years ago by cefiar
  0

• The 10uF electrolytic caps can be replaced by ceramics

  #3 opened 11 years ago by bobc
  1

• RAMPS-FD: Move Q201 away from F101

  #8 opened 11 years ago by cefiar
  2

• RAMPS-FD: U3 crowded for space

  #6 opened 11 years ago by cefiar
  1

• RAMPS-FD: Thermistor input protection

  #5 opened 11 years ago by cefiar
  1

• RAMPS-FD: Odd tracks around RP801, RP802, RP2, RP3

  #13 opened 11 years ago by cefiar
  0

• RAMPS-FD: Larger physical size resistor packs?

  #7 opened 11 years ago by cefiar
  0

• RAMPS-FD: Replace the ESTOP connector with a locking connector

  #9 opened 11 years ago by cefiar
  1

• mbeduinopresso-FD 3.3V regulator

  #2 opened 11 years ago by TopherMan
  0

• Due Pins issue in RIB

  #1 opened 12 years ago by TopherMan
  1