Probe Crash
Psyc0Flyer opened this issue · 4 comments
Psyc0Flyer commented
When using the Dock Z probe, it homes, goes to destination, probes, raises, reprobes and goes in for final probe BUT the probe plunger does not release to activate the probe and nozzle crashes into bed :/
cabbagecreek commented
Is this a BLTouch probe?
Psyc0Flyer commented
Yes. I use BLTouch on a Wanhao Duplicator i3 with an Azteeg X3 Pro board. S3D software and Marlin firmware
…On Fri, Feb 17, 2017 at 8:35 AM, Johnny Lindén ***@***.***> wrote:
Is this a BLTouch probe?
—
You are receiving this because you authored the thread.
Reply to this email directly, view it on GitHub
<#119 (comment)>,
or mute the thread
<https://github.com/notifications/unsubscribe-auth/ALBnoX32094nFjMQQTdFYOxGzd6i22r7ks5rdaIWgaJpZM4MDRGS>
.
--
Best regards!
Prometheus-3D
610-780-2714
This electronic transmission contains information which may be confidential
and/or privileged. This information is intended for use only by the
individual or entity named above and may not be shared elsewhere or
otherwise. If you are not the intended recipient (or the employee or agent
responsible for delivering this information to the intended recipient), you
are hereby notified that any use, dissemination, distribution, or copying
of this communication is prohibited. If you have received this information
in error, please notify me by electronic mail and delete all copies of the
transmission.
Thank you.
cabbagecreek commented
Okey. I Will build a 3D printer that covers this setup today. I even might do a video of the setup and testing.
cabbagecreek commented
The BLTouch version is released.. v0.19-beta This version covers the problem