cdberkstresser/fah-control

Actions apply to every slot instead of just the selected one

Closed this issue · 6 comments

braiam commented

If I pause/fold/finish any slot, the action is applied to both instead. This wasn't present on the previous version.

ffissore commented

I tried on linux and it works for me: I can pause/fold/finish a specific slot. which OS are you using?

braiam commented

Debian sid. The logs are consistent with this behavior.

00:35:03:Started thread 27 on PID 38752
00:35:13:FS00:Paused
00:35:13:FS01:Paused

I'm was using version 7.6.7 of the client, tried upgrading and got the same behavior.

00:39:41:FS00:Unpaused
00:39:41:FS00:Finishing
00:39:41:FS01:Unpaused
00:39:41:FS01:Finishing

Starting manager from the terminal didn't produce any log.

ffissore commented

I'm was using version 7.6.7 of the client, tried upgrading and got the same behavior.

Do you mean that this happening with the official upstream release of fah-control? Or with this fork?

braiam commented

It happens with this fork, as official one is uninstallable due dependency issues. The client (fahclient) is the official one.

ipkh commented

It is working correctly on Xubuntu 20.04

braiam commented

I don't know how to read. I'm using the buttons besides the slider. Those apply to all slots on the client. For some reason I came to believe that those only applies to the selected slot/unit. Probably messing too much with BOINC manager.

  • 👍1