can you help me with scheme of this broadlink?

[curla92]

[Steltek]

@chaeplin Thank you so much for the instructions! I used them as a base to mod my Broadlink RM mini 3 after finding out that it's a piece of garbage. (Can't deal with special characters in Wi-Fi password, or passwords longer than 32 characters. What a joke!)

@curla92 That looks like mine... Does it say "MINI_IR_N PCB V2.0" on the top?

Unfortunately I already hot-glued mine before labelling it, so I'll use your image...

Here's what worked for me:

Make sure you solder the IR OUT signal to both sides, otherwise only part of the IR LEDs will light up when you send a signal.
(You can also solder GND to the pin on the left side, above the 3.3V line used for the IR receiver if that's easier for you.)

[mrfoxbit]

Thanks @Steltek , It's worked for me.