Potential performance impact following upgrade to 0.10.0.0

[childe]

http://kafka.apache.org/documentation/#upgrade_10_performance_impact

The message format in 0.10.0 includes a new timestamp field and uses relative offsets for compressed messages. The on disk message format can be configured through log.message.format.version in the server.properties file. The default on-disk message format is 0.10.0. If a consumer client is on a version before 0.10.0.0, it only understands message formats before 0.10.0. In this case, the broker is able to convert messages from the 0.10.0 format to an earlier format before sending the response to the consumer on an older version. However, the broker can't use zero-copy transfer in this case. Reports from the Kafka community on the performance impact have shown CPU utilization going from 20% before to 100% after an upgrade, which forced an immediate upgrade of all clients to bring performance back to normal. To avoid such message conversion before consumers are upgraded to 0.10.0.0, one can set log.message.format.version to 0.8.2 or 0.9.0 when upgrading the broker to 0.10.0.0. This way, the broker can still use zero-copy transfer to send the data to the old consumers. Once consumers are upgraded, one can change the message format to 0.10.0 on the broker and enjoy the new message format that includes new timestamp and improved compression. The conversion is supported to ensure compatibility and can be useful to support a few apps that have not updated to newer clients yet, but is impractical to support all consumer traffic on even an overprovisioned cluster. Therefore, it is critical to avoid the message conversion as much as possible when brokers have been upgraded but the majority of clients have not.

For clients that are upgraded to 0.10.0.0, there is no performance impact.

Note: By setting the message format version, one certifies that all existing messages are on or below that message format version. Otherwise consumers before 0.10.0.0 might break. In particular, after the message format is set to 0.10.0, one should not change it back to an earlier format as it may break consumers on versions before 0.10.0.0.

Note: Due to the additional timestamp introduced in each message, producers sending small messages may see a message throughput degradation because of the increased overhead. Likewise, replication now transmits an additional 8 bytes per message. If you're running close to the network capacity of your cluster, it's possible that you'll overwhelm the network cards and see failures and performance issues due to the overload.

Note: If you have enabled compression on producers, you may notice reduced producer throughput and/or lower compression rate on the broker in some cases. When receiving compressed messages, 0.10.0 brokers avoid recompressing the messages, which in general reduces the latency and improves the throughput. In certain cases, however, this may reduce the batching size on the producer, which could lead to worse throughput. If this happens, users can tune linger.ms and batch.size of the producer for better throughput. In addition, the producer buffer used for compressing messages with snappy is smaller than the one used by the broker, which may have a negative impact on the compression ratio for the messages on disk. We intend to make this configurable in a future Kafka release.

[childe]

fetch api with new versions implemented