[?] What change to make RTL8715AQ based Tuya Camera work?
Opened this issue · 4 comments
I have a Tuya with RTL8715AQ chip on it. I can try to do the same way as guided here for RTS3903N if you think it will not brick the camera. If I should not do it, what can I do to get it working? Thanks.
I've never heard of the RTL8715AQ SoC, could you provide a picture of the board from your camera?
The SD card trick might allow you to gain root. It won't permanently write anything if you remove the tycam binary from your SD card.
I've just followed the steps, copying files to the sdcard and plug in the cam but haven't notice any glitch from the camera. I also powered off and on again and tried rtsp but no luck.
Hi,
Next time you ask something profide a clearer picture of the board you have as well as front and back.
Next to that this repository is specifically for the RTS3903N chipset based camera's.
However what i can tell you is that from the picture you send there seems to be 4 holes that might provide an UART interface?
But if i where you i would search for some other tuya repositories as this one is meant for a specific camera.