Troubleshooting Fibaro Dimmer 2 David Lomas code
Opened this issue · 2 comments
sidazad1 commented
Hi
I am new to ST but just got 25+ Fibaro Dimmer 2 installed in a new build. I followed all the instructions for using David’s Device Handler on IDE and iPhone. Used default setting for all parameters. However, my dimmer just is not responding to on/off or brightness commands from iPhone. Momentary switch works fine. What are possible ways to resolve this? I have a three wire system with momentary switches. Light load of 15 watts or do.
ingeting commented
I have the same problem with my newly installed dimmers as well. Did you find a solution?
sidazad1 commented
Yes,
I did the following steps, and all work now:
1) Add device handler to ST
2) Set the default parameters to what you want to set most of them at
3) Exclude each dimmer already added one by one
4) Remove the dimmer from ST if already not removed when performing exclusion
5) Reset the dimmer
6) Add the dimmer again
7) Wait for the dimmer to Sync
8) Go do the same for next dimmer
… On 7 Jan 2018, at 22:03, Inge Thorud ***@***.***> wrote:
I have the same problem with my newly installed dimmers as well. Did you find a solution?
—
You are receiving this because you authored the thread.
Reply to this email directly, view it on GitHub, or mute the thread.