[Feature request] Is there any ways to solder a 2811 led strip into the pcb, then control it by controller

Question

[Feature request] Is there any ways to solder a 2811 led strip into the pcb, then control it by controller

coadotvn opened this issue 4 years ago · 6 comments

I just solder it into the power led holes, then control it by a RF remote.
If there is any way to solder a led strip, to be controlled by the pcb, it will be best.

Answer 1 · 2020-07-16T09:47:04.000Z

coadotvn commented 4 years ago

Answer 2 · 2020-07-19T19:29:34.000Z

That's awesome. What kind of led strip did you use if you don't mind my asking?

Answer 3 · 2020-07-21T19:15:20.000Z

That's awesome. What kind of led strip did you use if you don't mind my asking?

any 5v led strip will works, just solder its pin to power led holes on the pcb, it will works

Answer 4 · 2020-08-27T12:10:02.000Z

You can solder the ws2812's data pin on PIN D0 and define config with QMK firmware. I did it and worked fine

Answer 5 · 2020-09-09T19:23:34.000Z

You can solder the ws2812's data pin on PIN D0 and define config with QMK firmware. I did it and worked fine

Can you pls share where is pin D0?

Answer 6 · 2020-09-10T00:21:18.000Z

you can find it from datasheet. This is 14th pin (RXD -PD0)