ct-Open-Source/tuya-convert

Deta Grid Connect Lights dead with vtrust-recovery SSID after flash

Inglan opened this issue · 2 comments

Inglan commented

Hi, the other day I was flashing 2 grid connect lights with Tasmota. The process went well for one of the lights (though I did have to configure tasmota), but the other will now not turn on, and it's SSID is vtrust-recovery. When I connect to the network, it disappears. I have seen people with the same issue, that say to ./start_flash.sh and then turn it on, but this does not work. It starts backing up the firmware but the transfer speed drops and then stops entirely.
Thank you
Inglan

kueblc commented

Have you tried skipping the backup? You can just comment that section out in start_flash.sh

  • 👍1
Inglan commented

No not yet. Will try when I get the chance