Flashing slzb-06m fails

Question

Flashing slzb-06m fails

fir3drag0n opened this issue 7 months ago · 7 comments

When I try to flash , I get the following error

00ncp-uart-hw-v7.4.2.0-slzb-06m-115200.gbl [##----------------------------------] 7% 00:08:22 Error: Firmware image was rejected by the device. Ensure this is the correct image for this device.

It is the gbl file for slzb-06m. What I need to change in order to flash it successfully?

Answer 1 · 2024-04-28T11:12:37.000Z

Are you flashing over USB? it should just work.

Can you run universal-silabs-flasher with -v option and post logs.

Answer 2 · 2024-04-28T11:13:36.000Z

I am flashing over Ethernet

Answer 3 · 2024-04-28T11:14:41.000Z

try USB (after selecting USB mode) there is less things to go wrong there.

Answer 4 · 2024-04-28T11:15:22.000Z

And how is the smlight zigbee radio firmware different from yours?

Answer 5 · 2024-04-28T11:23:01.000Z

I guess I have to set

--allow-cross-flashing

in order to bypass the check?

Answer 6 · 2024-04-28T11:26:16.000Z

smlight firmware is built against an older release of EmberNet(EZSP) than my builds. 7.4.2 is the very latest version available.

--allow-cross-flashing

that is only if you are changing firmware type, ie zigbee to multiprotocol or thread.

I dont know why you get that error after it started though. Would need to see logs...

Answer 7 · 2024-05-15T06:07:08.000Z

For me, this error was because the z2m container had restarted and connected back to the stick. After shutting down z2m, and then updating, it went fine.