CV and CLK in

[deetrone]

Implement 4 (?) CV in and 1 clock in. With 4 knobs a single MCP3008 ADC might be enough but in the end might need two of them.

Both hardware and software implementation required.

[daviderovell0]

CV and some gates can exceed 10V up to 12V (?), so the MCP3008 is not enough as it has a max input of 7.6V. We have to use another ADC or decrease the voltage though some additional circuits

[marcellillyes]

Yess I think we should first try out adding a simple op amp circuit to map the eurorack range to MCP range. daviderovell0 <notifications@github.com> ezt írta (időpont: 2020. szept. 2., Sze, 16:24):

…

CV and some gates can exceed 10V up to 12V (?), so the MCP3008 is not enough as it has a max input of 7.6V. We have to use another ADC or decrease the voltage though some additional circuits — You are receiving this because you were assigned. Reply to this email directly, view it on GitHub <#53 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ALHQBKB3AIECEEKKTSE5463SDZIQ7ANCNFSM4MV4IDXA> .

[marcellillyes]

Ill try model it in LTSpice Marcell Illyés <300000persec@gmail.com> ezt írta (időpont: 2020. szept. 2., Sze, 16:33):

…

Yess I think we should first try out adding a simple op amp circuit to map the eurorack range to MCP range. daviderovell0 ***@***.***> ezt írta (időpont: 2020. szept. 2., Sze, 16:24): > CV and some gates can exceed 10V up to 12V (?), so the MCP3008 is not > enough as it has a max input of 7.6V. We have to use another ADC or > decrease the voltage though some additional circuits > > — > You are receiving this because you were assigned. > Reply to this email directly, view it on GitHub > <#53 (comment)>, > or unsubscribe > <https://github.com/notifications/unsubscribe-auth/ALHQBKB3AIECEEKKTSE5463SDZIQ7ANCNFSM4MV4IDXA> > . >

[daviderovell0]

Sounds good. We can check also ADCs that take higher voltages so we can avoid making extra circuit