Not working normal pico
Closed this issue · 6 comments
FOR THE PICO NOT PICO W
Describe the issue
When I plug in the pico, it doesn't run the payload, instead shows up as a usb. If I push the jumper cable harder and reconnect, nothing shows up, but still decides not to run.
To Reproduce
Use the RPI Pico as normally
Expected behavior
Nothing works as it should
Additional context
Using the default payload after installing in setup mode
(could not understand issue #269 little weak english please help)
For a Pico W, there are two jumper options. One controls if the pico shows up as a usb device, the other controls if the payload runs on boot.
Check both jumpers to makes sure they are in the expected states.
it might be easier to control if you solder the header block to the pins and then use a wire with correct ends to make the jumper.
no I have the normal one
here is the video from start (ignore the sound)
https://drive.google.com/file/d/1mXAWOBFQyRVAzJwXiDy58AjDAMp6Xyhg/view?usp=sharing
please help
same problem. it used to work, now just it flashes 3 times, stops, flashes 2 times and then again 2 times in loop