dukelec/mbrush

Firmware Update

Opened this issue · 2 comments

Stebe242 commented

Mistakely flash firmware 5 on a V4 device now it is not booting and not recognize from Windows

grafik

grafik

dukelec commented
  1. Power off the printer
  2. Connect the printer to your PC through USB cable
  3. Press and hold the button on the top of the printer
  4. Turn on the printer power (the top button must keep pressed while turn on the power)
  5. Release the button on the top of the printer
  6. Check if your PC detect an "Ingenic boot device"
  7. Flash your printer again but with last v4 firmware by the "USB cloner" tool
Stebe242 commented

OK i forgot to hold the button but now it is recognize as an USB cloner device

grafik