ultrasonic

Question

Opened this issue 8 years ago · 5 comments

the ultrasonic MB1043 works alone properly but when it's put in the px4flow chip it doesn't give ground distance

Answer 1 · 2016-03-10T12:38:56.000Z

Have you soldered the jumper on the back of the ultrasound to force TTL on the serial ?

Answer 2 · 2016-03-10T14:27:21.000Z

Does the new firmware for the PX4Flow support taking the readings from the on board Ultrasonic?

Answer 3 · 2016-03-10T14:54:39.000Z

No i didn't
thanks again

Answer 4 · 2016-03-12T12:01:58.000Z

Sorry but i soldered it but it still doesn't give the distance

Answer 5 · 2016-03-12T17:13:45.000Z

Does one have to allow the use of the built in sonar and how to do so???