just mono channel available
rkmax opened this issue · 6 comments
I have installed and restated, I have the GSX 1000
- the volume dial does not change the volumen of the system, OK
- appear two outputs main and chat, OK
- main output should be 7.1, FAIL
also for some reason in the list of available outputs appear a Null output
Right now the only way to enable 7.1 on my system is adding something like this
load-module module-alsa-source device=hw:%cid,0
load-module module-alsa-sink device=hw:%cid,1 channels=8
Also reading the profile conf following the note
# If you do not want two devices but only one with a switchable profile
# (don't know why you would want that) uncomment the following two
# blocks and comment the one block above this comment.
After that appear that is working
no need to add
load-module module-alsa-source device=hw:%cid,0
load-module module-alsa-sink device=hw:%cid,1 channels=8
I have this issue too on Linux Mint, for some reason each new audio source defaults to GSX main audio chat output, despite setting main output as the default fallback device.
The way I've worked around it is by installing Pavucontrol and then opening it up with the audio source playing and manually switching it from chat output to main output.
While this is annoying, I do only have to do it once for every new program I use. Though I wish the entire system would default to main output rather than chat output as the only program I use chat output for is Discord.
after reading a bit pulseaudio documentation and some trial and error I was able to have two outputs which is really nice because I can select comm channel for discord as was intended
as soon I have some time again I'll polish and push my changes
@PsychedelicHell here my changes #16, probably you should uninstall the current evilphish installation before in order to avoid conflicts