Can't switch back to Simulator mode after setup
mirh opened this issue · 3 comments
mirh commented
I think the steps to reproduce are:
- configure your GPS receiver and connect it to AOG
- close AOG
- start it again and wait for precision to get good enough the "I'm lost" marker is no more
- get back to the "Serial Ports" window and disconnect it
- switch on simulator and click to restart
It's like the last two steps never happened.
richardklasens commented
You have to disconnect the USB cable, otherwise it will reconnect to the latest chosen serialport
mirh commented
I get that the connect/disconnect buttons may only be temporary to the local session.. But if I enable the simulator and I restart the program to get that, I am expecting that.
richardklasens commented
This is solved by using AgIO. Close it, turn on sim. As soon as agIO is running and is sending position data, sim is turned off again