Cannot remove default "Part fan"
Closed this issue · 1 comments
thijstriemstra commented
Fluidd Version
1.27
Browser
Firefox
Device
Desktop PC
Operating System
Windows, macOS
What happened
I defined the following 2 fans:
## FAN1 on CANBUS EXT1
[fan_generic fan_12v]
pin: ext1:PA0
kick_start_time: 0.5
## Depending on your fan, you may need to increase this value
## if your fan will not start. Can change cycle_time (increase)
## if your fan is not able to slow down effectively
off_below: 0.10
## FAN2 on CANBUS EXT1
[fan_generic fan_24v]
pin: ext1:PA1
But after refreshing/clearing browser cache I still see the "default" Part fan
listed in the GUI:
The Part fan
controls (obviously) don't do anything though.
What did you expect to happen
Ability to remove the Part fan
.
How to reproduce
Use an empty printer.cfg
without any fans, it'll still show the Part fan
.
Additional information
No response
pedrolamas commented
Not entirelly sure, but we have the part fan "hard coded", proabably some old code!
We will remove it for next release.