Questions regarding build steps

[wrongbaud]

Hello,

I am trying to build gdb so that I can target an ARC CPU through OpenOCD. I am building on a Raspberry Pi and am able to comminciate with my target ARC CPU over JTAG and I would like to get a GDB instance built such that I can start stepping through the firmware. I have built the latest release on my RPi as follows:

./configure 
make

I am able to get things to build, however when I run ./gdb/gdb I cannot select the ARC architecture, all that is available to me is ARM.

I understand that this is likely something very simple that I am not doing properly with my ./configure step - can someone please point me in the right direction I have tried the following:

./configure --enable-targets=all

as well as

./configure --enable-targets=arc

Neither of those results in the ability for me to properly select the ARC architecture within GDB.

I apologize for asking this question here - but it takes quite a while to build on the Pi and I have spent a fair amount of time on this tonight.

[wrongbaud]

I am an idiot. Wrong repository.