The LGX Mosquito printhead is only compatible with Bear MK3s X-axis (8mm rods) and genuine Mosquito hotend (regular or magnum).
There is no filament sensor!
Bondtech recommends E-steps for the LGX set to 400/800 (16/32 microstepping).
Print settings, PETG (ABS for fan duct), 0.2mm layer height, 4 perimeters, 5 layers for bottom and top, min. 20% Gyroid infill, no supports.
Check the Doc-section for nuts and bolts.
Designed for M3 brass heat set inserts with D=4.6mm, L=5.7mm
Only for experienced users! Use at your own risk!
Based on the BondtechPrusa i3 MK3S / MK2.5S Mosquito Extruder (www.bondtech.se).
X-Carriage is based on Bear Upgrade from Grégoire Saunier (https://github.com/gregsaun).
The fan duct is a modified version of RH_Dreambox Fan duct (https://www.thingiverse.com/thing:4217188).