gilestrolab/ethoscope

request: sleep depriver module instructions/arduino code

Closed this issue · 6 comments

rjs360 commented

Hi all, I am looking to build a few sleep depriver modules for my ethoscopes.

A few years ago there was fairly detailed documentation on building and running (via arduino code) the dc motor based "tube spinner" module (referred to as the "rotational module" here: https://www.science.org/doi/10.1126/sciadv.aau9253), but (I might be missing something) I can no longer find this information.

Might anyone still have information/files/instructions for these? Thanks for any info on this.
-Ruud

ggilestro commented

Hi. The ethoscope manual still lives at http://lab.gilest.ro/ethoscope
Instructions for the old module can be found here.
Instructions to the new module can be found here

pepelisu commented

Hi. The ethoscope manual still lives at http://lab.gilest.ro/ethoscope Instructions for the old module can be found here. Instructions to the new module can be found here

Just as note. The links are asking for a login into notion.

rjs360 commented

Thanks both! Missed those links completely earlier.
-Ruud

  • 👍1
ggilestro commented

@pepelisu this is worrying. are you sure about that??? They should be openly shared to the world and If I open those in incognito I am not asked for a notion login.

pepelisu commented

Links are working for me now, however before I was been redirected to the notion login page.

rjs360 commented