Can't debugging on macOS Sequoia with intel mac
sonientaegi opened this issue · 2 comments
Please answer the following before submitting your issue:
Note: Please include any substantial examples (debug session output,
stacktraces, etc) as linked gists.
If this is about source listing not showing up (or breakpoints not being
accepted) while running in a container please read our
FAQ
first.
- What version of Delve are you using (
dlv version)? 1.23.0 - What version of Go are you using? (
go version)? 1.22.5 - What operating system and processor architecture are you using? macOS 15, darwin/amd64
- What did you do? #3797
- What did you expect to see? #3797
- What did you see instead? #3797
I have both macarm and mactel. Thankfully, I could launch debugger on my macarm following #3797. And I do the same on my mactel but it doesn't work at all as the very first macarm did after installing Sequoia. Below is the error message.
Warning: no debug info found, some functionality will be missing such as stack traces and variable evaluation.
could not launch process: could not read debug info (decoding dwarf section info at offset 0x0: too short) and could not read go symbol table (could not find rodata struct member)
Could anyone plz check the issue on mac with intel?
@aarzilli
I made some mistake. I built the image with go 1.22 and debugging section was not generated. After building with go 1.23 I could find __zdebug* sections. Thanks for helping.