Laminar flow imperfections
0x2b3bfa0 opened this issue · 3 comments
0x2b3bfa0 commented
FDM prints have slight imperfections that keep the inner channel's surface from creating a good laminar flow.
aleksclark commented
This doesn't seem completely solved, in testing the mask produced by #6 I was not able to achieve more than 2cm H2O with air.
see: https://www.youtube.com/watch?v=yGmyCOS2pSA
https://www.youtube.com/watch?v=ehNEK6gB7iQ
0x2b3bfa0 commented
Referring to your water test, it looks like a small section of the channel is clogged. Might that affect the performance?