"Unable to save data" when attempting to change Motor Controller type
Closed this issue · 2 comments
HighMasterGogo commented
Hardware tab -> Motor section -> Controller drop down -> Select "Internal DAC"
Click Apply
Click Save
Debug reports...
[16:25:31] [Motor]Data successfully sent (42) bytes
[16:25:31] [Save-11]Data successfully sent (9) bytes
[16:25:36] Unable to save data
Go back to drop down and it remains on "PWM".
chicknsoup commented
Thank you for your report. To be able to detect the problem, please spare some time to fill out the below form:
1. Brief description of the issue 2. Which firmware and UI version are you using? 3. Windows version? 4. Which feature is broken? 5. Does it occur frequently? (Rarely, sometimes, always, etc.) 6. Steps to re-produce the issue? 7. Screenshots and logs 8. Other information
HighMasterGogo commented
This was an error with versioning names. The issue was with V.0.21.1.4 (which I believe is a typo).
V.0.20.4.0 is the correct version and does not have this issue.