Access point with password is not working
anishkhannayellapu124 opened this issue · 2 comments
Hi,
Thank you very much for the driver.
Using this driver, i have connected TL-WN725N
hostapd version 2.10
Linux 5.10.145 with RT patch
AP is working without any authentication, once i enable authentication WPA2 with CCMP. Device is disconnecting for every 5mins , with below error.
################################################################################
root@s32g399ardb3:~# wlan0: interface state UNINITIALIZED->COUNTRY_UPDATE
wlan0: interface s[ 30.299460] RTW: assoc success
t[ 30.299901] RTW: set group key camid:0, addr:da:a1:2c:8a:62:00, kid:1, type:AES
a[ 30.300399] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
te COUNTRY_UPDATE->ENABLED
wlan0: AP-ENABLED
wlan0: STA 32:9f:f2:81:4[ 43.647354] RTW: ============ STA [32:9f:f2:81:4f:32] ===================
f[ 43.647373] RTW: mac_id : 2
:[ 43.647376] RTW: wireless_mode : 0x0b
3[ 43.647379] RTW: mimo_type : 0
2[ 43.647382] RTW: static smps : N
[ 43.647385] RTW: bw_mode : 20MHz, ra_bw_mode : 20MHz
I[ 43.647388] RTW: rate_id : 0
E[ 43.647390] RTW: rssi : -1 (%), rssi_level : 0
E[ 43.647394] RTW: is_support_sgi : N, is_vht_enable : N
E[ 43.647397] RTW: disable_ra : N, disable_pt : N
[ 43.647400] RTW: is_noisy : N
8[ 43.647403] RTW: txrx_state : 0
0[ 43.647406] RTW: curr_tx_rate : MCS7 (L)
2[ 43.647409] RTW: curr_tx_bw : 20MHz
.[ 43.647411] RTW: curr_retry_ratio : 0
1[ 43.647414] RTW: ra_mask : 0x00000000000fffff
[ 43.647414]
1[ 43.648534] RTW: set group key camid:0, addr:da:a1:2c:8a:62:00, kid:1, type:AES
:[ 43.648708] RTW: send eapol packet 1/4
[ 43.653755] RTW: recv eapol packet 2/4
a[ 43.665608] RTW: send eapol packet 3/4
s[ 43.670996] RTW: recv eapol packet 4/4
s[ 43.671199] RTW: set pairwise key camid:1, addr:32:9f:f2:81:4f:32, kid:0, type:AES
ociated
wlan0: AP-STA-CONNECTED 32:9f:f2:81:4f:32
wlan0: STA 32:9f:f2:81:4f:32 RADIUS: starting accounting session 4A48FC0DA62AE92D
wlan0: STA 32:9f:f2:81:4f:32 WPA: pairwise key handshake completed (RSN)
wlan0: EAPOL-4WAY-HS-COMPLETED 32:9f:f2:81:4f:32
wlan0: STA 32:9f:f2:81:4f:32 IEEE 802.11: disassociated
wlan0: AP-STA-DISCONNECTED 32:9f[ 354.093861] RTW: ERROR Free disconnecting network of scanned_queue failed due to pwlan == NULL
[ 354.093861]
:[ 354.100486] RTW: ERROR Free disconnecting network of scanned_queue failed due to pwlan == NULL
[ 354.100486]
f[ 354.102136] RTW: ERROR Free disconnecting network of scanned_queue failed due to pwlan == NULL
[ 354.102136]
2:81:4f:32
wlan0: INTERFACE-DISABLED
wlan0: INTERFACE-ENABLED [ 354.131010] RTW: set group key camid:0, addr:46:80:a3:46:76:2b, kid:1, type:AES
[ 354.146880] RTW: assoc success
[ 354.147341] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
wlan0: STA 32:9f:f2:81:4f:32 IEEE 802.11: asso[ 357.801434] RTW: ============ STA [32:9f:f2:81:4f:32] ===================