jcallaghan/3d-printing

Sink overflow support

jcallaghan opened this issue · 4 comments

jcallaghan commented

I want to house and secure an Aqara water sensor in my sink over the overflow hole without impeding or block it from functioning as a overflow hole.

jcallaghan commented

More details about the sensor here jcallaghan/home-assistant-config#17

jcallaghan commented

I found a really cool design on Thingiverse which is very close to the design I was going to create. After two test prints, I was able to scale this design for my use-case perfectly.

jcallaghan commented

To track the prints I recorded the XYZ values I used to scale the model so I could get the perfect scale.

Print X Y Z Result
0 28.97 25.57 16.6 Original.
1 20 17 11 Too small.
2 35 30 20 Too big.
3 27 23 15 Fits although could be deeper.
4 28 25 20 Perfect.