This repository contains code for exploring Speed Studio's configurable NFC tags during the Open Hardware Training as part of OpenDoTT.
The Arduino Firmware send the detected NFC tag's identifiers via Serial connection to the host machine. On the host machine Node Red is used to program the receiving end.
To install Node Red use a terminal and run npm install
in this folder.
Use the Arduino IDE to open Arduino Firmware/NFC2Serial/NFC2Serial.ino
and upload to the board of your choice.
The Seeed Studio Grove NFC module was connected on the RS232 serial connector.
To run the Node Red flow, start it in the terminal with npm run
.
Source code newly written by the researcher in this repository is licensed under the GNU Public License (GPL).
Any other original content is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Doctoral Researcher: Jens Alexander Ewald
Supervisors: Jayne Wallace (University of Northumbria, Newcastle upon Tyne), Mel Woods (University of Dundee), Mehan Jayasuriya (Mozilla Foundation), Max von Grafenstein (UdK Berlin), Davide Gomba (Officine Innesto)
This project is part of Open Design of Trusted Things (OpenDoTT) doctoral training network and has received funding from the European Union’s Horizon 2020 research and innovation program under the Marie Skłodowska-Curie grant agreement No. 813508.