Sherpa Mini fit test
Closed this issue · 8 comments
Sherpa Mini has a mount available, but fit test is pending. See the docs.
I use that mount (https://github.com/jon-harper/E34M1/blob/testing/STL/drives/drive_sherpa_mini.stl), the only thing that did not quite work was to get that screw in there - but it works okayish without :-)
I use that mount (https://github.com/jon-harper/E34M1/blob/testing/STL/drives/drive_sherpa_mini.stl), the only thing that did not quite work was to get that screw in there - but it works okayish without :-)
Was the screw hole off or is there not clearance with the ADXL?
There is no clearance (without the board of course) - I can remove my board and make a photo later to better show the problem
There is no clearance (without the board of course) - I can remove my board and make a photo later to better show the problem
Gotcha, I've got it installed now and see the issue. Did you try with a button head screw? I'm using the PIS front and it just fit.
Similar, but I just rasped it of a bit and now I got the screw in there 🤷♂️
Do you happen to have a button head screw to test it with? It fits with a button head on mine but I'm using the PIS front.
ah sorry, I assumed you meant SHCS because I was using the button head screw initially. As you can see I used it for the other two screws as well. Yes I am using one now, but after I scraped off a bit.
So it's no longer an issue for me if you want to close the ticket xD
ah sorry, I assumed you meant SHCS because I was using the button head screw initially. As you can see I used it for the other two screws as well. Yes I am using one now, but after I scraped off a bit.
So it's no longer an issue for me if you want to close the ticket xD
I made a note about the clearance issue and recommended a button head screw there. I'll push the updated docs soon.
Thanks for your help!