ipv6 address lost

[shugo-chara]

Thanks for your work, it has been working fine on my AX-82u.
Until I changed a setting and found that the ipv6 address was missing.

dns：8.8.8.8，1.1.1.1
AX-82U merlin 3.0.0.4.386

log：
log.zip

[jumpsmm7]

Thanks for your work, it has been working fine on my AX-82u. Until I changed a setting and found that the ipv6 address was missing.

dns：8.8.8.8，1.1.1.1 AX-82U merlin 3.0.0.4.386

log： log.zip

@shugo-chara
Thank you for pointing this out, this may be a good topic for you to post on the SNBforums as this is a custom option a user would/could choose, however, ipv4 DNS can often times resolve both A and AAAA request and it should be allowed to if able. Otherwise addresses that may only be resolvable VIA AAAA configurations may not be available and some users internet may otherwise be broken by AAAA request being disabled. However, this is not an issue of this installer. This installer does everything it is intended to do, which is install AdGuardHome to Asuswrt-Merlin routers.

As you can observe this behavior, by disabling IPV6 AAAA DNS you effectively disable your clients ability to resolve over IPV6 DNS to AAAA addresses as well as IPV4 to AAAA address. This shows that the button being used in AdGuardHome is working correctly, and why this IPv6 test site shows issues with your ipv6. (your clients are not able to properly connect). Only enable this if you intend to disable the IPV6 side of your network.