[question] Could you connect more SPI devices to the QSPI boot flash bus?
JensRestemeier opened this issue · 2 comments
JensRestemeier commented
I was wondering, if you run the code from RAM, could you connect more flash or an SD-card to the QSPI pins? You won't have the execute-in-place available, but could store data?
Or is there a hardware/software limitation?
That would free up a few pins for the N64 bus.
dogtopus commented
You actually can and it has been done before IIRC. Although bank-switching like this tends to be expensive latency-wise and consoles that talk to the flashcart are usually very picky about any sorts of latencies.
JensRestemeier commented
Thanks, I was expecting that only some kind of menu (or homebrew) would access those extra devices, and could avoid cartridge access while those devices are mapped in.