Readme.md some issues
Silveriomrs opened this issue · 1 comments
Good evening,
Following some instructions about rotatory encoder, I have make 2 mistakes due to confuse info, perhaps it could be better to modify it, in order to make it more clear.
- black text almost cannot be read.
- Representation of rotatory encoder seems to be wrong.
For the first point, I suggest to do annotations with some kind of grey background or similar. Because they are written in the photos.
For the second... perhaps remove the circle from the symbol or a note make it clear which side of pins are referenced.
Thank you very much for your great work.
The problem is poor rendering in dark mode. Really a dark-mode alternative is needed, or the pages need to be forced into light mode, or the diagrams need to be light/dark agnostic.
The soldering pads are fairly symmetric. It doesn't matter which way round you connect the SW/GND pins. And DAT/CLK is actually trial and error -- if it goes backwards, swap DAT/CLK. This is mentioned in the troubleshooting section.