[BUG ]4Max Pro - After use M0, resume is possible only from command prompt

Question

[BUG ]4Max Pro - After use M0, resume is possible only from command prompt

Jaroslaw75 opened this issue a year ago · 5 comments

Hallo,

I'm not sure is it a bug or my foult.
I'm using M0 to pause print and insert the nut, after that printer stopping, but resume is possible only from command prompt (if PC is connected I can send M108)
According to Marlin M0 spec. LCD should display message to confirm and unpause machine.

Answer 1 · 2023-11-01T20:27:13.000Z

Yes, this is a bug. You can try M600 to pause the print, but it seems that there is an issue with the old Anycubic tft. I'll take a look!

Answer 2 · 2023-11-01T20:40:50.000Z

The M600 works, I can resume from the LCD, unfortunately, after using the M600, the printer automatically removes the filament. This is a little bit problematic.

Answer 3 · 2023-11-01T21:19:57.000Z

You can use parameters on M600 for custom filament unload/load length. Alternatively you can configure your M600 with M603. See https://marlinfw.org/docs/gcode/M603.html.

Maybe this could be a workaround for you?

Answer 4 · 2023-11-02T07:23:55.000Z

Thanks for the tip, I'll test it.

Answer 5 · 2024-06-05T17:43:34.000Z

This is fixed in Version 1.5.4