[BUG] Disconnect after homing in version 1.5.3
CraftoHohenvels opened this issue · 3 comments
Bug Description
When starting a print the printer homes, which is common behavior. So when starting a print (or basically just homing) the printer disconnects upon finished homing.
This is on my AMP.
Steps to Reproduce
- Install version 1.5.3 (proper version for the configuration)
- Flash it via Octoprint
- Start a print or home
Expected behavior: complete the homing an move on
Actual behavior: complete the homing and disconnect
Edit: on the OctoPrint logs everything is fine
Does this behavior also happen if you install an older firmware? To me it sounds like a hardware error. Possibly in the heating cartridge.
Sorry for the late response!
It only happened with the version 1.5.3, earlier versions are not problem - same goes for the "vanilla" firmware. I haven't tried version 1.5.4 yet.
I would rule out a hardware problem
That's a good start. Please try 1.5.4, as it fixes a few bugs that affect the control of the end stops and motors.
Otherwise, I would like to ask you to write down exactly what kind of printer you have and what has been changed. I will then try to reproduce it and find the bug.