Nozzle crash after performing Z_TILT_ADJUST with the Eddy coil
cssi-dev opened this issue · 4 comments
I tried printing the first part after switching to the new probe. I was suprised to learn, that my print was canceled during the print start macro.
Error:
probe triggered prior to movement
with horizontal_move_z: 5
So I switched it to horizontal_move_z: 10(even though In the bed section the horizontal_move_z is just 2 ), to then get the nozzle crash because the printer after getting all the readings moved all z axes way to far.
I get that you are not supposed to use the eddy coil for homing because of the temprature drift. But please let us use the Tilt adjust. I don't want to switch every 5-10 prints between the probes just to readjust the z axis when it gets out of wack.
Steps to reproduce:
- Home the Printer
- Start
Z_TILT_ADJUST - Be ready to shutdown the printer befor something bad happens
klippy.log
You mean move this Issue to the other repo?
Yeah it'll get more attention over there.
This repo was setup when I first built the guide before it was adopted by BTT. It's maintained on their official repo now.
Instructions etc have changed which could also solve some issues
Ok, thank you