lairdubois/lairdubois-opencutlist-sketchup-extension

Rough dimensions of sheet good parts not calculating properly?

Closed this issue · 2 comments

d3rryc commented

Hey, there!

I'm running into trouble running the cutting diagram for my sheet goods. I backed all the way down to running a diagram for a single piece of plywood. The piece is small enough to fit on the material regardless of the part's orientation. As you can see, I have the oversizes set to zero in both directions, while both the kerf and trim sizes are small enough not to create issues, either. However, as you can see from my parts list, the rough sizes being calculated are WAY larger than they should be.

Help?
Derry

cutting diagram config
material properties
oversizes
parts list

bbeaulant commented

Hi @d3rryc,

There's no miscalculation, but you define part oversize to 96" and 48" in material propreties.

148631448-ec502da3-c2b9-4d11-b3c1-08731bc2dfb2

Click on the following button to understand part dimensions :

148631450-9afe47f0-62dc-4dbb-ba80-45907a81a8ff

Have a nice day,

d3rryc commented