Confirm Wallbox Copper SB

[Dixet]

Since Wallbox Pulsar is in the documentation and Wallbox Copper SB supports OCPP v1.6j I tried to switch to OCPP.

I can conform Wallbox Copper SB to work perfectly with below sensors and controls. Some small differences with Wallbox Pulsar.

All sensors visible in attached screenshot, some confirmed working:

Metrics
Energy Active Import Register
Energy Session (gives a different reading than Energy Active Import Register)
Power Active Import (sensor is available but always show 0)

Current Offered (maximum charging current available)
Time Session (elapsed time from start of charging session)

Current Import (instantaneous charging current - I use this instead of Power Active Import)

Diagnostics
Status Connector (shows the current state of available/preparing/charging/finishing/suspended etc)
Stop Reason (reason the charging session was stopped)
Charger Status (current status of the charger)

Controls
Charge Control
Availability
Maximum Current (sets maximum charging current available)
Reset