Vampyr drive cv too responsive

Question

Vampyr drive cv too responsive

Closed this issue 5 years ago · 3 comments

Petervos2018 commented 5 years ago

I could not figure out what range to use for the drive cv on the vampyr filter even an extremely small amount of voltage was too much.
I think it's way too sensitive..
Love the sound

Greetings Peter.

Answer 1 · 2019-04-20T15:59:23.000Z

Thanks for reporting Peter... will check that soon

Answer 2 · 2019-07-01T08:34:57.000Z

It is ok so far, other users seem to be ok with it :) Use attenuverter ;)

Answer 3 · 2019-07-01T10:08:25.000Z

So to be on the same side
we both mean the same thing, I mean that the cv range to modulate the drive knob is much to small I think the whole range needs about 1v.
When the drive is in the middle position and I just want to slightly modulate left and right a bit I need about 0.0001V otherwise I go into the "red" on both sides.
And to do that I should use an attenuverter to make the range about +-0.002V from F.I. an LFO.

You know we can use ranges from +-10V in VCV.
OK I'm exaggerating but what I mean is its a very small range.

Waiting for your release of V1 (It looks gorgeous).

Greetings Peter.