loxicmd create lb can not change existing lb mode
vincentmli opened this issue · 1 comments
vincentmli commented
I have existing lb as below:
[root@bpfire-3 ~]# loxicmd get lb -o wide
| EXT IP | SEC IPS | PORT | PROTO | NAME | MARK | SEL | MODE | ENDPOINT | EPORT | WEIGHT | STATE | COUNTERS |
|-------------|---------|------|-------|------|------|-----|---------|-------------|-------|--------|--------|----------|
| 1.1.1.1 | | 80 | tcp | lb1 | 0 | rr | onearm | 2.2.2.2 | 9080 | 1 | active | 0:0 |
| | | | | | | | | 3.3.3.3 | 9080 | 1 | active | 0:0 |
| 10.99.99.99 | | 80 | tcp | | 0 | rr | default | 192.168.3.6 | 80 | 1 | - | 0:0 |
I want to change the lb1 mode
from onearm
to fullnat
, so I run this
[root@bpfire-3 ~]# loxicmd create lb 1.1.1.1 --tcp=80:9080 --name=lb1 --mode=fullnat --endpoints=2.2.2.2:1,3.3.3.3:1
ProtoPortpair: map[tcp:[80:9080]]
Debug: response.StatusCode: 200
lbrule-exists error
it complains lbrule-exists error
, but if I add or remove one of the endpoints along with the mode fullnat
change, it succeeded
[root@bpfire-3 ~]# loxicmd create lb 1.1.1.1 --tcp=80:9080 --name=lb1 --mode=fullnat --endpoints=2.2.2.2:1
ProtoPortpair: map[tcp:[80:9080]]
Debug: response.StatusCode: 200
Success
so it appears I can't use loxicmd create lb to only change mode
or select
, is this bug?
UltraInstinct14 commented
Yes it was not supported before but has been added