Memory: zsh: killed ./shennina.py

[Semperfi1775]

Hello, I've run into an issue with Shennina.
So far, It seems when running in "training mode", it uses up all my memory and kills the process.
Here I am training a metasploitable3 system.
Shennina is running on Kali inside UTM, on my M1 Mac. I've bumped the memory to 16 GB.
Once it's OOM, it kills the process.

The screenshot is not too long after the process was killed.

[Semperfi1775]

So, I wanted to provide an update. I’m not sure if there is continued work on this project or not.
However, I was able to solve my memory issue. Maybe it'll help.
Whenever I launch it in training mode; it would run for a few hours and then receive an OOM error with Python.

My setup was as follows;
Mac M1, using UTM Kali VM.

So, I decided to run inside a Python Virtual Environment & install all requirements.

python3 -m venv shennina/venv
source shennina/venv/bin/activate

Verison: Python 3.11.2

Installed when in venv:

┌──(venv)─(yemx㉿kali)-[~]�
        python3 -m pip install matplotlib==3.4.3
	python3 -m pip install tensorflow-hub==0.12.0
	python3 -m pip install pymetasploit3
	python3 -m pip install termcolor
	python3 -m pip install python-nmap
	python3 -m pip install requests
	python3 -m pip install flask
	python3 -m pip install pandas==1.1.5
	python3 -m pip install numpydoc==0.9.1
	python3 -m pip install tensorflow-estimator==2.7.0
	python3 -m pip install tensorflow==2.12

Verified Requirements
./verify-pre-requirements.sh

Need to Install Docker

       sudo apt install docker.io
 	sudo groupadd docker
 	sudo usermod -aG docker $USER

Config.py
default settings were fine.

Setup msfrpc
sudo nano msfrpc-config.json

Msfrpc - no issues running
./run-msfrpc.py

Exfiltration Server - no issues running
./run-server.sh

Launching Shennina - when using privileged access: need to use the venv path

Which Python
┌──(venv)─(yemx㉿kali)-[~]
└─$ `which python3`
	/home/kali/shennina/venv/bin/python3

(venv)─(kali㉿kali)-[~/shennina]
└─$ `sudo /home/kali/shennina/venv/bin/python ./shennina.py --training-mode --lhost 172.17.0.2 --target 192.168.64.21 `

Then proceeded with the next phase: exploitation

[1124672065]

不知道你最后结果怎么样了，有没有运行成功，我遇到的问题与你一样，无法训练，所以不能得到.h5文件这个模型文件，导致shennina.py 也无法顺利运行

[yuni159]

I am getting stuck at the 'Starting worker 0' stage. Could you please share how you resolved it?