Question about axis
Opened this issue · 0 comments
Hello, i've been using your code and so far so good except that i think my axis (the white dot on the gui software) is getting disconfigured. When i first started it was on the middle, but after a while using the shifter (i only have the shifter and i'm using it with a g29 wheel) the axis went a little to the left and thus making my gears overwrite each other, i made the last and best possible configuration, leaving only a little void area between neutral and all the other gears. My question is: it's possible to calibrate only the axis instead of the gears zones ? Because i'm afraid that if get's disconfigured again i'll be unable to calibrate it.
I'll keep using it and if it happens i'll post here again
Here is the pic: