1.1D tx ptt problem

Question

1.1D tx ptt problem

TA1FM opened this issue a year ago · 8 comments

I was using v0.9, I installed v1.1D, the TX LED does not light up and it does not switch the radio to TX. There was no such problem in v0.9.

Answer 1 · 2024-01-24T00:15:28.000Z

Here the ptt is working normally

Answer 2 · 2024-01-26T05:04:28.000Z

Check in MOD Tab of GPIO and active pinout.

Answer 3 · 2024-01-26T20:56:56.000Z

I made the esp32 igate circuit in v08, I connected it to an external handheld radio, I did not use a module like SA668, tx led and ptt were working fine, when I installed v1.1D on the same system, tx led and ptt did not work.
Even though I made the PTT GPIO settings in the MOD tab in the interface, it does not work. I tried many of the settings in the RADIO tab, but it still did not work. I could not figure out why. When I go back to the old v08 or v09 software, it works without any problems.
I follow your work with pleasure, thank you for your interest.
TA1FM

Answer 4 · 2024-01-30T07:50:36.000Z

If SQL pin signal not used, it to fix SQL GPIO = -1

Answer 5 · 2024-01-30T19:19:22.000Z

I'm sorry to take your valuable time, but when I set SQL GPIO to "-1", esp32 keeps resetting during TX.
https://photos.app.goo.gl/8rRFmnzmNKU61nzv5

Answer 6 · 2024-01-31T03:50:39.000Z

I've fixed this in the version 1.2b, please update firmware again.

Answer 7 · 2024-01-31T16:42:35.000Z

I installed V1.2b, but during TX, ESP resets again. If I turn off the INET2RF switch, there is no problem as only igate.

Answer 8 · 2024-03-04T18:49:22.000Z

There is no problem in the software without an OLED screen, but in the software with an OLED screen, the problem was solved when I added 2 pull-up 4k7 resistors to the data paths of the screen.