shikari-scenarios

A collection of Lima Templates that will be used with Shikari.

Prerequisites

The following tools are required to run these scenarios:

HashiCorp Packer (if you are building custom images)
CDRtools (if you are building custom images)
Lima
Shikari

You can use the Brewfile shipped in this repository to install all the dependent tools.

$ brew bundle
Using hashicorp/tap
Tapping ranjandas/shikari
Installing ranjandas/shikari/shikari
Using hashicorp/tap/packer
Using hashicorp/tap/nomad
Using hashicorp/tap/consul
Using cdrtools
Using qemu
Using lima
Using socket_vmnet
Homebrew Bundle complete! 10 Brewfile dependencies now installed.

Setup Socket_vmnet

Run the following commands to configure socket_vmnet.

$ limactl sudoers > etc_sudoers.d_lima
$ sudo install -o root etc_sudoers.d_lima /etc/sudoers.d/lima

Run Test VM

Run a test VM to verify the socket_vmnet is configred properly. Verify that the lima0 interface inside the VM has an IP Address.

$ limactl start template://alpine --network=lima:shared

$ limactl shell alpine ifconfig lima0
lima0     Link encap:Ethernet  HWaddr 52:55:55:96:B6:B1
          inet addr:192.168.105.2  Bcast:0.0.0.0  Mask:255.255.255.0
          inet6 addr: fe80::5055:55ff:fe96:b6b1/64 Scope:Link
          inet6 addr: fdff:bed9:f801:6df1:5055:55ff:fe96:b6b1/64 Scope:Global
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:6 errors:0 dropped:0 overruns:0 frame:0
          TX packets:9 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:1252 (1.2 KiB)  TX bytes:1291 (1.2 KiB)

Once the above pre-requisites are met, you can proceed using Shikari to launch clusters based on various scenarios.

Usage

The following steps will build a VM image with Consul and Nomad installed, which will be used as the source of the VMs created using Shikari.

Build the base VM image

$ cd packer 
$ packer init hashibox.pkr.hcl
$ packer build -var-file variables.pkrvars.hcl hashibox.pkr.hcl

This will build the VM image into the .artifacts directory in the current directory.

Now you can run the scenarios by going into specific scenario directory and invoking the template using Shikari.
NOTE: You can avoid passing the image on the CLI by setting the image.location inside the template file (hashibox.yaml) to point to the newly created image file in the previous step. (this should end with .qcow2). Run the following command to get the absolute path to the image file.
```
readlink -f .artifacts/<image-dir>/<image-file>.cqow2
```
```
$ cd scenarios/nomad-consul-quickstart
$ shikari create --name demo --servers 3 --clients 3 -i ../../.artifacts/<image-dir>/<image-file>.cqow2
```
The above example command will create 3 servers and 3 clients using the image we previously built using packer.
Export the environment variables to access the cluster services.
```
$ eval $(shikari env -n demo)
```
You can exec into the servers using the limactl shell <vm-name> command.

natemollica-nm/shikari-scenarios

shikari-scenarios

Prerequisites

Setup Socket_vmnet

Run Test VM

Usage