Lift/drop print head on photo take
nvtkaszpir opened this issue · 1 comments
nvtkaszpir commented
Happened to have some top layer scratches, it was 160x160x2 mm flat PETG slab and it probably warped probably due to cooldown and the large flat size on the bed.
Things to consider:
- per-layer: on layer change lift print head a bit and move to the button trigger, on way back drop print head in target location
- on final layer: as above, but lift higher?
nvtkaszpir commented
actually it is better to use slighly higher z hop per layer.
also updated custom end gcode to take a photo after final z lift.