/jailbreak-11

Experimental PS4 jailbreak for 11.00 and lower

Primary LanguageRustMIT LicenseMIT

Jailbreak for 11.00

This is an experimental jailbreak for PS4 11.00 or lower based on TheFloW proof-of-concept exploit. This jailbreak is under development and does not working yet.

Requirements

Same as TheFloW proof-of-concept, except Python and GCC are not required.

Setup

You need to connect the PS4 and the computer with an Ethernet cable without any Ethernet switch in the middle.

Running

Run the following command on the computer that connected with the PS4 to find the index of connected port:

ip link

It will output something like:

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: enp3s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UP mode DEFAULT group default qlen 1000
    link/ether ??:??:??:??:??:?? brd ff:ff:ff:ff:ff:ff

My computer has only one Ethernet so 2 is an obvious index for me. Once figure out run the following command:

sudo ./jailbreak-11 INDEX

Replace INDEX with the Ethernet index then open the PS4 and go to Settings > Network > Set Up Internet Connection > Use a LAN Cable > Custom > PPPoE. Enter a random PPPoE User ID and PPPoE Password.

Building from source

Prerequisites

  • Rust on the latest stable channel

Install additional Rust target

rustup target add x86_64-unknown-none

Install additional tools

cargo install cargo-binutils
rustup component add llvm-tools

Build the payload

cargo objcopy -p payload --target x86_64-unknown-none --release -- -O binary payload.bin

Build the jailbreak

cargo build

After this you can follow the instructions on the Running section by changing the ./jailbreak-11 to ./target/debug/jailbreak-11.

License

MIT