oblique/create_ap

Connected to my AP but no connection !

Ed-09 opened this issue · 1 comments

Ed-09 commented

I have a big problem in Archlinux.

when I run create_ap, it works fine for about 10 seconds and after that it kinda stop.

my phone is connected to the AP but no connection!

I"ve noticed some things, when I run iwconfig here's the outputs:

`enp0s25 no wireless extensions.

ap1 IEEE 802.11 ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=15 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Power Management:off

wlp0s26u1u3 IEEE 802.11 ESSID:"DFDFDDFD"
Mode:Managed Frequency:2.412 GHz Access Point: 77:8B:S7:B8:9E:99
Bit Rate=28.9 Mb/s Tx-Power=20 dBm
Retry short long limit:2 RTS thr:off Fragment thr:off
Power Management:off
Link Quality=47/70 Signal level=-63 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:8 Invalid misc:699 Missed beacon:0

ap0 IEEE 802.11 ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=15 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Power Management:off

lo no wireless extensions.

wlo1 IEEE 802.11 ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=15 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Power Management:off
`

here's what im doing to run create_ap :

create_ap wlo1 wlp0s26u1u3 XXXX pass --hidden --daemon

HELP please

same here bro