VontarX3(s905x3, Gigabit Ethernet) Support writing emmc to use
d5stick opened this issue · 10 comments
Standard chat template, no routine, no chat.
**Device Information |
- SOC: [S905x3]
- Model [Vontar X3, RAM 4GB, EMMC 128GB]
**Armbian Version |
- Kernel Version: 6.1.9
- Release: Bullseye
- meson-sm1-hk1box-vontar-x3.dtb <- uEnv.txt
**Describe the bug |
Armbian-install completes but does not boot from EMMC.
reattaching the pendrive and reboot the device, it will boot from pendrive.
Describe the problem in detail and attach screenshots if necessary.
- Flashed standard android Pie rom
- Flashed USB pendrive
- Booted Armbian from USB
- Ran armbian-install. No errors complete. Remove the pendrive, reboots. Device does not boot.
Option 506
Option EXT4
What is the error log? Where did you stop?
You can change to 5.15 and try
Is there a TTL-tag on the back of the motherboard?
Are VONTAR X3
and HK1 Box
the same device? Can you flash the Android system of HK1 on X3 and use it?
You are using the hk1 option, adapt to hk1, if this is not a device, but the android system is common, you can flash the android system on the x3 first, and then test to write armbian into emmc
There are 4 holes in the lower left corner of the picture on the back of the motherboard, corresponding to the V
R
T
G
on the front is the acronym of ttl
.
V: 3v
R: rx
T: tx
G: gnd
Making progress!
Flashed several HK1 roms, finally found one that works with this box. (u219.HK1_BOX_1000M_9.0.2020.11.16.11.05)
Started Armbian on the USB pendrive, started the armbian-install on the box.
Armbian booted!
For now this can be closed. Vontar X3 boxes have to have the HK1 firmware in order to install to the local EMMC.
Thanks for the help :)!
Share your download link for this Android system
, I will transfer it to:
https://github.com/ophub/kernel/releases/tag/tools
Please share a photo of your device. The model code can be clearly seen in the box bottom photo
, which is convenient for everyone to compare and use.
Just installed kernel 6.1.9, which boots.
The IMG file i used: https://www.filefactory.com/file/5db9u9cc2ucc/u219.HK1_BOX_1000M_9.0.2020.11.16.11.05.img.7z
The burner including license files i used: https://github.com/d5stick/amlogic-s9xxx-armbian/tree/main/VontarX3Files
Thanks for sharing, I will add it to the device list and share a configuration with hk1.
For some reason, system boots from emmc only after using armbian-install -m yes -a no
.