Batocera v38 - 8bitdo SN30 pro BT controller not working with Yuzu when auto controller config is set to "auto"
Closed this issue · 2 comments
8bitdo SN30 pro BT controller
Batocera v38 2023/12/9
switch updater last run 2023/14/9
Prior to running the Switch updater my controller was working as expected. After running the update, my controller no longer works in-game (except hotkey+start to exit).
I have tried yuzu & yuzu-early-access, keeping auto controller config
set to auto
and experience the same results with both.
If I go to yuzu-config > emulation > configure > controls
and change the input device
from any
to xbox 360 controller 0
all the buttons presses are recognized.
If I then choose ok
and launch a game from within yuzu-config
, my controller works fine. If I then exit yuzu-confi
g and go back to ES launching a game with auto controller config
set to off
, my controller is working fine. Setting auto controller config
to auto
causes the controller not to work again.
yuzu logs
with control cfg set to auto & off are attached.
auto-cfg controller - yuzu mainline.zip
auto-config controller OFF yuzu mainline.zip
Resolved in latest commit. Please test and confirm.
I ran the updater today and my BT SN30 pro is now working with yuzu.
Thank you!