how to operate. two one channel relay connected to one laptop
combat007 opened this issue · 3 comments
combat007 commented
My problem is I have two one channel relay hid device.
the command "./hidusb-relay-cmd enum" show the following output
Board ID=[959BI] State: R1=OFF
Board ID=[959BI] State: R1=OFF
but when I provide the command "./hidusb-relay-cmd ID=959BI ON 1" it works for one device but changing the number to 2,3 or 4 dosen't help operating second device. How can I achieve this. How can I operate the second one.
ImXron commented
@combat007 Were you able to figure this one out?
Thanks
tcsaddul commented
They should have a different serial no. I guess the library does not have the capability to write serial no of the relay.
On Thursday, March 15, 2018, 5:59:13 AM GMT+8, ImXron <notifications@github.com> wrote:
@combat007 Were you able to figure this one out?
Thanks
—
You are receiving this because you are subscribed to this thread.
Reply to this email directly, view it on GitHub, or mute the thread.
combat007 commented
Yes
…On Mar 15, 2018 3:29 AM, "ImXron" ***@***.***> wrote:
@combat007 <https://github.com/combat007> Were you able to figure this
one out?
Thanks
—
You are receiving this because you were mentioned.
Reply to this email directly, view it on GitHub
<#23 (comment)>,
or mute the thread
<https://github.com/notifications/unsubscribe-auth/AHJVzNeaP55VUoNWCDkGAf0PpDKj-szsks5teZKvgaJpZM4Rumyt>
.