LYWSD03MMC-z temp/hum is null
ruvasik opened this issue · 3 comments
ruvasik commented
Last seen N/A
Availability [Disabled]
Device type EndDevice
Zigbee Model LYWSD03MMC-z
Zigbee Manufacturer Xiaomi
Support status Not supported
IEEE Address 0xa4c1386b31feea57
Network address 0xA87B
Firmware build date 20240226
Firmware version 3001-0120
Power Battery 100%
Interview completed True
Battery
Remaining battery in % 100%
Temperature Measured temperature value N/A°C
Humidity Measured relative humidity N/A%
Linkquality Link quality (signal strength) 23lqi
In state i see only { "battery": 100, "linkquality": 23 }
On try change reporting interval
Bind 0xa4c1386b31feea57/1 msTemperatureMeasurement from '0x00124b001cd502f5/1' failed (AREQ - ZDO - bindRsp after 10000ms)
Request 'zigbee2mqtt/bridge/request/device/configure_reporting' failed with error: 'Bind 0xa4c1386b31feea57/1 msTemperatureMeasurement from '0x00124b001cd502f5/1' failed (AREQ - ZDO - bindRsp after 10000ms)'
In HA logs i see not errors.
z2mqtt now external_converters is lywsd03mmc-z.js
also tried lywsd03mmc, lywsd03mmc-legacy-z2m
ruvasik commented
In dev console i can read values
Humadity measuredValue
Read result of 'msRelativeHumidity': {"measuredValue":4421}
Temperature measuredValue
Read result of 'msTemperatureMeasurement': {"measuredValue":2284}
pvvx commented
The clusters binding and the configuration report (Zigbee 3.0) do not work for you.
How did You write the firmware?
If via a UART adapter, errors are possible. Write the BLE version and download Zigbee via OTA.
ruvasik commented
Firmware updated by OTA