incorrect CHANGE-IT for first connect wifi ?!

[sajjads24]

hi
i am install torbox 5.2 on raspberry pi 3 but for first connect with wifi incorrect defualt password : CHANGE-IT
now how fix it ?
and set new password for wifi ?

[sajjads24]

i am manual change file hostapd.conf

`# This configuration file was modified by TorBox
# Please don't change it manually, unless you know what you are doing
# If you delete values (even the ones with #), the TorBox menu will not re-add them again!
# You find a backup of the default file in torbox/etc/hostapd
# IMPORTANT: don't remove or change the "country_code=US" value! Otherwise, the
# 5 GHz 80 MHz settings will most likely crash hostapd!

interface=wlan0
driver=nl80211
ssid=TorBox
country_code=US
hw_mode=g
channel=6
ieee80211n=1
ieee80211ac=1
wmm_enabled=1
#ht_capab=[HT40-][HT40+][SHORT-GI-20][SHORT-GI-40][DSSS_CCK-40]
#vht_oper_chwidth=1
#vht_oper_centr_freq_seg0_idx=42
macaddr_acl=0
auth_algs=1
ignore_broadcast_ssid=0
wpa=2
wpa_passphrase=18121812
wpa_key_mgmt=WPA-PSK
rsn_pairwise=CCMP
`
but can not connect wifi with mobile samsung and pc !
how fix and connect wifi ?

[radio24]

The image file contains this configuration. Thus, I don't think it is a configuration error and, therefore, too little information to help you.

• Did you use the image file or try to update an older system?
• Do you see any error messages at the end of the boot process after rebooting TorBox? Could you please attach a screenshot of these messages?

For me, also good to know is the following points (after a reboot with failed wifi):

• the content of /etc/hostapd/hostapd.conf
• the content of run/torbox.run
• what is the output of sudo systemctl status hostapd.service?
• what is the output of sudo systemctl status rc-local.service?

In the meantime, I will set up a test system using the new image file to see if there is an error. Honestly, because I already tested it, it is doubtful that something on the image is corrupt. Nevertheless, one never knows...

[radio24]

Thank you for bringing up this issue. I found three critical errors on the image file and have to redo it in the following hours (I took it offline for the time being). Update 07.01.2023: Now, I also found the reason for these problems: Preparing the image, I'm using pishrink. However, so far, I didn't use the option -p to remove logs, apt archives, dhcp leases and ssh host keys. Using this option the first time with building the TorBox v.0.5.2 image led to these errors.

1. rc-local.service is missing
For an unknown reason, sudo cp etc/systemd/system/rc-local.service /etc/systemd/system/rc-local.service is missing [here](https://github.com/radio24/TorBox/blob/2888fdfd61d3b0d805119d4b94fba35d8d3c1af5/install/run_install.sh#L879)

A quick fix is the following command:

sudo cp /home/torbox/torbox/etc/systemd/system/rc-local.service /etc/systemd/system/rc-local.service
sudo systemctl daemon-reload
sudo reboot

2. The new version of pishrink purged too much in /var/log
A quick fix is the following command:
sudo mkdir apt exim4 journal nginx openvpn runit tor

3. SSH host key not regenerated without shell login
A quick fix is to login locally, which will trigger the regeneration of the SSH host key.

[radio24]

I just uploaded the fixed image using the same URL and updated the SHA256 hash. Feedback would be greatly appreciated.